Ottoman Bed Guide: Lift Types, Safety and What to Pay
An ottoman bed lifts the whole sleeping surface on gas struts, turning the space under the mattress into one large storage void. On a double that is roughly 600 to 700 litres, which is several times what four drawers hold.
That is the appeal. The catch is that the mechanism is a moving part under load, and it is where cheap ottomans fail. Everything below is about choosing one that will still lift in five years.
How the mechanism works
Two gas struts, one at each end of the base, push the lid up when you release the catch. The struts are pressurised cylinders, the same principle as a car boot, and they are rated by the weight they can hold.
When the lid is closed, the struts are compressed and storing energy. When you lift, that energy is released and helps you raise the mattress. The struts are not there to hold the lid up on their own, they are there to make the lift manageable.
That matters because people overload them. A king mattress at 45kg plus bedding and a topper can exceed a cheap strut pair's rating, and the result is a lid that will not stay up or, worse, comes down slowly while you are leaning in.
End lift or side lift
This is the decision that depends on your room, not your taste.
An end lift hinges at the head end and raises the foot. It needs about 60cm of clear floor at the foot of the bed to open fully.
A side lift hinges along one long side and raises the other. It needs about 50cm of clear floor along one side.
In a room where the bed sits between a wall and a wardrobe, the foot is often blocked. That rules out an end lift completely, which is why side lift exists. Check with a tape measure before ordering, because this cannot be changed afterwards.
On a king or super king, most ottomans are two halves that lift independently. That is not a gimmick: lifting a full 180cm ottoman with a mattress on it is not something one person can do.
The weight limit nobody checks
Ask for the strut rating. A reasonable pair holds 40 to 60kg of mattress and bedding. A king pocket sprung mattress alone is often 45kg.
Three signs that the struts are undersized. The lid sinks slowly when you let go at half height. You have to push it up past a certain point. Or it holds when empty and drops when the mattress is on.
If you are buying for a super king or for a heavy mattress, ask specifically. A supplier who cannot answer the question has not specified the part.
What actually fits inside
The internal depth is usually 25 to 30cm, measured from the base board to the underside of the lid. That is enough for bedding, suitcases, shoes and out-of-season clothes. It is not enough for anything tall.
A double gives roughly 600 to 700 litres, a king about 700 to 800, and a small double 450 to 500. Compare that with a two-drawer divan at around 180 litres.
Two practical points. The void is one open space, so things slide around unless you use bags or boxes. And the weight you put in sits on the base board, which is usually 15 to 18mm board — it will bow if you fill it with books.
Keep heavy items toward the edges and near the strut mounts, not in the middle of the span.
Safety, honestly
The lid is heavy and it closes under its own weight once the struts pass a certain angle. That is a finger trap, and it is the reason ottoman beds are not suitable for a child's room without supervision.
Three things reduce the risk. A lock or catch that requires a deliberate action to release. A lid that stops before fully closing when the struts are new. And keeping the storage area clear of anything a child would want to reach.
If the bed is going in a room where young children play, a divan with drawers is the safer choice for the same storage job. Our divan beds range covers the drawer layouts.
What breaks first
The struts, then the hinge plate, then the base board.
Struts lose pressure over time, usually after four to six years of regular use. They are replaceable, and a replacement pair is not expensive, but you need to know the length and the force rating, so keep the paperwork.
The hinge plate fails when it is screwed into chipboard rather than bolted through a reinforced block. That is the difference between a £260 ottoman and a £450 one, and it is invisible in a photo.
Ottoman or divan with drawers
Both give you storage under the bed, and they suit different rooms.
A divan with two drawers gives you about 180 litres and needs 60cm of clear floor in front of each drawer. It does not need the rest of the bed clear, so it works in a room where the bed is boxed in on three sides.
An ottoman gives you three to four times the volume, but it needs clearance on one whole edge: 60cm at the foot for an end lift, 50cm at the side for a side lift. In a small room that clearance is often the thing you do not have.
The other difference is what you can store. Drawers suit folded bedding and shoes because they are shallow and you can see into them. An ottoman suits suitcases, boxes and bulky items, but the void is one open space, so anything loose slides to the middle.
If you are choosing between the two, measure the clearance first and let that decide. Our divan bed guide covers the drawer layouts, and the small rooms guide covers which one opens in a tight room.
What to pay
Our ottoman beds start at £260 for a double. That gets you a working mechanism and a fabric base.
Between £400 and £600 you are paying for a properly rated strut pair, a reinforced hinge, and a thicker base board. That is the band worth aiming for if the bed is used daily.
Below £250 for a king, something has been specified down. It may still be fine for a spare room that opens twice a year. It is not the one to buy for a main bedroom.
Before you order
- Measure the clearance at the foot and along one side, and decide end lift or side lift from that.
- Ask for the strut rating and compare it with your mattress weight.
- Check the internal depth against what you actually plan to store.
- Check the hinge is bolted, not screwed into chipboard.
- Confirm the mattress weight limit for the base as a whole, not just the lid.
An ottoman is the best storage solution in a small bedroom, and it is the one bed type where the mechanism matters more than the fabric. Buy the mechanism, then choose the colour. If you are pairing it with a mattress, our mattresses page lists the weights, which is what the struts have to carry. Delivery is free nationwide and the delivery areas page lists the towns we cover.









